Hardwire Kit for Blackvue Dashcam for Land Rover Defender L663

Power Tap-in Loom
Hardwire Kit for BlackVue X Series Dashcam

for Land Rover Defender
L663

This listing is for a plug and play power tap-in loom
kit for the Blackvue Dashcam to fit the Land Rover Defender L663.

This is a plug and play solution – no cutting or
wiring skills needed.

Our plug and play interceptor loom plugs in
above the overhead console to give the necessary power feed without
having to alter your vehicle’s wiring.

The loom has the correct power connector on
the end for BlackVue X Series dashcams.

This cable is compatible with the following
cameras:

DR900x/DR900x Plus Series

DR750x/DR850x Plus Series (Not compatible
with DR750x-2CH LTE Plus)

DR590x Series

Note that the connector on this lead has 3
pins (Ground / Battery +ve/ Ignition) which is used by most of the X
series cameras – check compatibility with your BlackVue model before
purchasing.

This is not a genuine Land Rover or Blackvue product.

Fitting details

Disconnect your battery +ve lead (under the drivers
seat) before fitting the loom to the vehicle – this makes it less
likely for power surges that could damage car circuits when plugging /
unplugging the overhead console.

The ignition live feed comes from the body control
module – if this is overloaded the circuit is isolated and can be
reset with an ignition cycle ( turn the car on and off again )

The battery positive feed comes via fuse 31 (5 Amps
) �in the fusebox behind the glove box.

If you have any issues with your car that needs
investigation by a Land Rover dealer it is best to disconnect this
loom so the vehicle is returned to its original configuration.

See below fitting video (video shows Nextbase kit but
the fitting process is the same for the loom).

Which Vehicles will this fit
?

This WILL
fit the Land Rover Defender L663 (we have also tested with our MHEV and
have had no reported issues on PHEV models)