LED Rear Light Ballast Resistors (x2) for Range Rover Sport 2010 Lights

LED Indicator Light Ballast Resistor kit ( PAIR ) to fit Range Rover Sport 2010 Rear light Conversion This listing is for a PAIR of 15 Ohm Resistors to fix the indicator fast flash problem on the Range Rover Sport 2010 LED rear light conversion. The original rear lights used normal bulbs which draw more current than the LED bulbs. By adding this resistor ACROSS the earth ( Black wire on car loom ) and the indicator signal wire ( Green+red wire on car loom ) this then makes the ECU and flasher unit think that all is OK. Rather than fitting to the loom side of the car it is better to glue the resistor to the rear of the lights as shown in the picture. We have done some trials and you can get these lights to work with lower value resistors but these get hot so we have found that 15 Ohm is the highest value resistor ( runs cooler ) that can be used and everything works OK. This resistor will also stop the check indicator bulb message that can display in the dash. These are not genuine Land Rover parts. The terminals provided are ideal for soldering short wires to and have 2 mounting holes if required. Power Rating:25W Resistance:15 ohm Resistance Tolerance:� 5% Resistor Element Material:Wirewound External Length:48mm ( including contacts ) External Depth:15mm External Width:28mm Full Power Rating Temperature:20�C Insulation Resistance:10000 ohm Operating Temperature Range:-55�C to +275�C Fixing Centers LxW:20 x 18mm Fitting Details Connect one end to the earth wire and the other end to the indicator signal . Which Vehicles will this fit ? This item will fit Range Rover Sport models from 2005 to 2009 when fitting 2010 LED rear lights ( with LED indicators )